The using of sealant is for the purpose of adequately sealing, therefore, much attention should be paid to the dosage, position and the surface of sealant. M Diameter Thread Bolt with spring washer Valve bolt of bolt pitch. The looseness should be even and gradual. Identification mark stamped on the front and No. The gasket surface must be free from grease and foreign substances. Install the cap to the chuck.
Do not pour oil or water on applied locations or do not start the engine until sufficient time approximately one hour passes. Notice: 1 The rear oil seal cover should be mounted quickly on the condition the sealant is not dry 15 min. Remove the garage jack which supports the engine and transmission assembly. Identification of inlet side and exhaust side Engine front Front mark 1. Insufficient dosage of sealant may result in leakage, while superfluous dosage of sealant may result in the overflow of sealant and jam the passage of water or oil, or narrow the passage. Check and compare the height difference between the plunger and the new hydraulic lifter. Tightening torque of bolts and nuts Torque Kg.
M Front cover and oil pump Oil drain plug Oil pan Oil suction filter bolt and nut Oil pressure switch Pressure relief plug Oil suction filter bracket bolt Front cover bolt Plug Flange bolt Oil pump cover bolt Oil pump cover screw Piston and connecting rod assembly. Identification of piston diameter dimension Identification mark thrusting Plus 0. Adjust the stem seal insertion length, obeying the following procedures. Apply the engine oil to the valve stem seal to set the chuck. B rocker arm B 3. Confirm whether con- duction exists between the winding and stator iron core, if yes, replace the stator assembly. Insert the chuck and the sleeve into the outer pipe to fit the nut as shown in the illustration.
Otherwise foreign body may enter the pressure chamber which is full of oil. To easily know how many times the chuck is turned, put the mark at the position shown in the illustration. Too small amount causes leakage while too much amount squeezes out to block or narrow water and oil passages. Or lightly driving a smooth and thin gasket scraper in mating surfaces is useful, but full care must be exercised not to damage mating surfaces. Engine oil pan drain plug 3.
Therefore, it is absolutely essential to apply a correct amount of liquid sealant continuously without break to eliminate leakage from joints. Tighten each camshaft bearing cap mounting bolts to the specified torque in the order shown, and then tighten the front camshaft bearing cap mounting bolts as well. In some cases, however, it is necessary to lightly tap parts with a wooden hammer or similar tool to break sealant between mating surfaces. Remove the engine oil pan installed temporarily. Notes: There shouldn t be any oil or lubricating grease on the surface of O ring seal.
Tightening torque of special parts is shown at the beginning of each group. In order to describe all parts belonging to an assembly, assemblies are further divided into several parts. A rocker arm A 2. The scraper blade and the main ring has the specified upper. . Use the plastic hammer to insert the valve stem seal.
It is necessary to pay attention to an application amount, application procedure and applied surface condition for this gasket to fully achieve its purpose. Remove sealant from the engine oil pan and cylinder block surfaces. Install the valve spring seat. Remove the engine oil pan mounting bolts. Be sure to correctly install them by referring to the identification marks. Set the valve stem seal insertion length L of 14. Replace if not conform 12mm to standard.
Completely enclose the periphery of mounting holes. Notes: Adhering of water or grease to the toothed-belt will sharply shorten its service life. . . . .
. . . . .