. The cooling system is designed to: Reduce operating temperatures of cylinder head. Fill differential to lower edge of fill plug. Internal transfer case repair is not covered. While the hydraulic unit and control module function as one unit, they are replaceable individually. Remove torx screws from exhaust camshaft sprocket arrows.
Clean main chassis ground terminal next to battery. Engine assembly, removing and installing Note: The intake manifold must be removed as described earlier to facilitate engine assembly removal. Warnings and cautions For personal safety, as well as the protection of sensitive electronic components, adhere to the warnings and cautions on the following pages. Have driveshaft rebalanced or replace if necessary. Remove set screws left hand thread on ends of intake and exhaust camshafts.
To recheck the adjustment of the parking brake see Brakes. Fit exhaust camshaft splined sleeve. I personally use all the resources I can put my hands on. Remove coolant level sensor 9 by twisting counterclockwise and pulling out of bottom of tank. Lift up manifold enough to disconnect positive cables from starter motor terminal arrow.
Note: In this step, mass air flow sensor remains attached to rubber air duct. Worn or damaged universal joints usually require replacement of the driveshaft. Wipe the body dry with a soft cloth towel or chamois to prevent water-spotting. As an alternative, standard valve seal removal tools are available from most automotive parts stores. Tightening torques pan M12 Oil pan to engine block M6, 8. When installing strut assembly into car: Make sure locating pin arrow of strut bearing is positioned correctly in strut tower.
If possible, use gloves to protect your hands. P-code Fault type and Signal type and Explanation code function range shunt resistor limitation voltage then secondary ignition voltage is detected and shunt resistor may be faulty. Remove third power steering mounting bolt arrow and remove pump from its mounting bracket. Pressure release When intervention is necessary: The changeover valve in the hydraulic unit energizes and closes inlet valves for the two front wheels and the rear wheel with traction. Remove intake manifold mounting nuts arrows. Learn more about Amazon Giveaway.
Plug all open fuel lines. Pull down on center of driveshaft to facilitate removal. Mark oxygen sensor harness connectors in order to avoid reversing them during installation. Corrosion can be washed away with a baking soda and water solution that will neutralize acid. Be sure to use a torque wrench when tightening the sensor mounting bolt. Allow the cooling system to cool before opening or draining the cooling system. Do not smoke or work near heaters or other fire hazards.
Change bit is monitored to indicate proper function. One method is to tightly wrap a shop towel around a fuel line fitting and loosen or disconnect the fitting. P-code Fault type and Signal type and Explanation code function range transistor and component exists. Contaminated coolant may damage the engine or cooling system. Replace control arm bracket bolts.
Tighten down head nut A to lock feet into position. Remove left tie rod outer end nut arrow. Checking for spark is difficult on engines with distributorless ignition systems. Drive ball joint out from subframe using soft hammer. It can only be installed in one position. Be sure to reinstall coil grounding harness. Remove retaining nuts arrows and bearing cap 1 of intake camshaft.