If all children cannot be seated and restrained properly in a rear seating position, properly restrain the largest child in the front seat. Some mirrors also have a second pivot point. This is normal hybrid operation and helps deliver fuel efficiency and performance. Shuffle plays music on the selected album or folder in random order. Correct vehicle usage and the authorized disposal of waste, cleaning and lubrication materials are significant steps toward this aim. Perhaps the users of ManualsCat.
Assemble the two halves of the transmitter back together. It is the only Extended Service Plan authorized and backed by Ford Motor Company. See Sitting in the Correct Position in the Seats chapter. The passenger cannot protect the child from injury in a crash. Do not attempt to pull the card to remove it as this could cause damage. At the next opportunity, do the following: 1. The automatic locking mode is not available on the driver safety belt.
Adjust the temperature control to the desired setting. If any lamps remain on after starting your vehicle, refer to the respective system warning lamp for further information. Note: If you disconnected the negative battery cable, it will be necessary to reset memory features. However, the essential information in the illustrations is always correct. No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission. When Value Charge has been selected charging may not begin upon plugging in.
In addition, the retractor is designed to lock if the webbing is pulled out too quickly. Push the lever forward again or pull the lever toward you to switch the high beams off. Allow the belt to retract. In frontal crashes, the safety belt pretensioners can be activated alone or, if the crash is of sufficient severity, together with the front airbags. Safety belt assemblies not in use during a crash should also be inspected and replaced if either damage or improper operation is noted.
If this occurs, let the belt retract slightly and pull webbing out again in a slow and controlled manner. Inspect engine oil filter for corrosion Perform multi-point inspection recommended. The shoulder portion of the safety belt should be positioned across the chest. We strongly recommend that you use extreme caution when using any device that may take your focus off the road. We recommend that you take some time to get to know your vehicle by reading this manual. Do not introduce any item thicker than this under the booster seat.
Perhaps the users of ManualsCat. It is an index that relates to how much weight a tire can carry. Placing your arm over a deploying airbag can result in serious arm fractures or other injuries. Seek up or next C. The system displays off-peak times for weekdays; the remaining hours of the day are considered peak time. The system uses information from the front passenger sensing system to determine if a front seat passenger is present and therefore potentially in need of a warning.
Squeeze the buttons and slide the height adjuster up or down. Properly seated occupants sit upright, lean against the seat back, and center themselves on the seat cushion, with their feet comfortably extended on the floor. The following drawings compare the ideal fit center to a shoulder belt uncomfortably close to the neck and a shoulder belt that could slip off the shoulder. Unlocking the Doors Two-Stage Unlock Type 1 Type 2 Press the button to unlock the driver door. All seating positions in this vehicle have lap and shoulder safety belts.
By referring to the market unique supplement, if provided, you can properly identify those features, recommendations and specifications that are unique to your vehicle. The lap belt portion of a combination lap and shoulder belt should be positioned low across the hips below the belly and worn as tight as comfort will allow. Improper use of the lighter can cause damage not covered by your warranty, and can result in fire or serious injury. The lower anchors at the center of the second row rear seat are spaced 18 inches 46 centimeters apart. These are some of the symbols you may see on your vehicle.
The lower anchors at the center of the second row rear seat are spaced 18 inches 46 centimeters apart. To check this, grab the seat at the belt path and attempt to move it side to side and forward and back. Never wear the shoulder belt under the arm. The indicator lamp will illuminate for a short period of time when the ignition is turned to the on position to confirm it is functional. The safety belt warning light and warning chime turn off.
This type of attachment method eliminates the need to use safety belts to attach the child seat, however the safety belt can still be used to attach the child seat. Position the child safety seat in a seat with a combination lap and shoulder belt. There is a second pre-fuse box attached to the 12-volt battery terminal in the rear of your vehicle. If your child restraint system is equipped with a tether strap, and the child restraint manufacturer recommends its use, Ford also recommends its use. The more that you know about it, the greater the safety and pleasure you will get from driving it. Read Steps 1 - 4 thoroughly before proceeding with the programming procedure.