Turn the key to the on and off position 3 times. If you do not have them, skip to step 12 as you will effectively disable them until you can redo this procedure. Call Nissan for specifics or check the owners manual Here's the sequence enter car, close and local all doors. It's not necessary to re-program your working remote head keys as those will continue to work. As soon as the car started the solid red key fob light appeared in the dash and the push start showed red as well but it still started and ran like normal. Instructions are listed in the owners manual on how to do this. Door locks should respond by locking and unlocking.
Open driver's door, turn ignition off. Snap the two halves back together. Do this for each fob. We also have you covered with three-button remote entry smart keys, transponder keys, a variety of other keyless entry remote flip keys, and more. Relea … se open button.
Free programming is included when applicable for all Mazda6 2009 Keys and keyless remote entry. Within 20 seconds press any button on the first keyless remote to be programmed. Repeat the previous step to program up to four transmitters. Just remember that you must also re-program your currently working remotes at this time also as if they ar … e new since prior remotes are erased. If the module has successfully entered program mode, it will lock and then unlock all doors. For the vehicles without Smart Entry System 1.
It requires you to press the lock button on the fob and turn your ignition on and off multiple times. The emergency key also needs to be cut to match your original key you have. Reprogram any existing remotes at this time as they have been erased. Insert the key into the ignition. Electronically unlock the doors Switch on door or working transmitter.
Hold lock and unlock near dashboard for a few seconds. When done properly the doors will automatically lock and then unlock. Key has to be cut as well at purchase location. It doesn't appear to be any sort of battery error in the key fob as I have new batteries in both of them. Press any button on the remoter, the door lock should activate. They must be programmed by an automotive locksmith or dealership.
Leave key in the ignition. You will have to get this key programmed by a local automotive locksmith or Mazda dealership. Repeat this step for each transmitter. Our industry-leading customer service staff is here to help. If any do not program, check the batteries. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you! Most of these remotes use a 2032 battery - check the Owners Manual To replace the battery:. Press any button on the 1st transmittor.
Step 8: Additional remotes, repeat Step 7 for up to 3 remotes total. Remove key from ignition and locks should lock and unlock again. You may also have to program the key if you have replaced a battery, as this can cause the key to no longer be synchronized with the car. Doors should then lock and unlock. Door locks should respond by locking and unlocking.
Insert key into the ignition. The Mazda6 has sold over one million units worldwide since its introduction, hitting this sales milestone faster than all previous Mazdas. Close all doors, open drivers door, key out of ignition. Step 7: Press any button on remote 1 twice. Lock and Unlock the drivers door using the power lock switch on door panel. Within 20 seconds, press any button on the second keyless remote.
Step 5: Close and open the drivers door 3 times. This procedure requires original programmed keys. Replacement of the battery will not cause the remote to have to be reprogrammed. The vehicle will lock and unlock the doors automatically. Let the 20 seconds expire.
Step 5: Close and open the drivers door 3 times. After leaving the dome light on for 2+ days, I got a jump on the completely drained battery. If you only have one remote then skip to step 4. Door locks will cycle to confirm programming mode. Open and close drivers door 3 times ending with door in the open position.