Continuing to drive your Mazda in this condition could cause damage to your transaxle. Latch the hook onto the anchor bracket. See the manufacturer's instructions on the child-restraint system for belt routing instructions. Ø Don't descend steep grades in gear with the ignition switch turned off. Please be aware that this manual applies to all models, equipment and options. Because of this, two stations may sometimes be picked up on the same frequency at the same time.
Chipped paint can lead to rust forming on your Mazda. Maintenance and Care How to keep your Mazda in top condition. If it is still not retracting properly, have it inspected at an Authorized Mazda Dealer. Drive to the side of the road and park off the right-of- way. In Case of an Emergency Helpful information on what to do in an emergency.
Hydrogen gas, produced during normal battery operation, could ignite and cause the battery to explode. We at Mazda design and build vehicles with complete customer satisfaction in mind. Moving it can very easily cause the driver to abruptly turn to the left or right. Sudden changes in ambient temperature. If the washer doesn't work, inspect the fluid level page 8-27. Consult an Authorized Mazda Dealer for refrigerant inspection. Additional advanced keys can be obtained at an Authorized Mazda Dealer.
Have it towed to an Authorized Mazda Dealer. This unit can only display English including numerals one-byte characters. Ø Do not use accessories that are not genuine Mazda accessories or the equivalent. If the unit does not operate correctly after 1 hour, consult an Authorized Mazda Dealer. After 20 seconds, the system is fully armed. Scan tuning Press the scan button to automatically sample strong stations. Set the temperature control dial to the desired position.
If replacing the battery by yourself, follow the instruction below. If any of these occur, consult an Authorized Mazda Dealer as soon as possible. This is not a technician's manual. Cautions If servicing is required, contact an Authorized Mazda Dealer. When the Simulation starts the button will be displayed as , and when selected, it will cause the Simulation to advance quickly. Overhead light Rear , Luggage compartment light 1.
Properly loading your vehicle will provide maximum return of vehicle design performance. Push the trunk board down to its original position, and tighten the tether strap following the child-restraint system manufacturer's instructions. Install the new bulb in the reverse order of removal. Warning Operating the system will distract the driver from looking ahead of the vehicle and may cause an accident. Fuel consumption Trailer towing causes higher fuel consumption. This may lead to serious engine damage and may void your warranty.
The warning lights except brakes should be inspected before the engine is started page 5-38. Press down the cruise control switch and release it at the speed you want. Select an avoid area to be deleted. Make sure the headlight switch is off. Please consult an Authorized Mazda Dealer. The cruise main indicator light illuminates. However, Mazda recommends that all maintenance services be performed at the recommended time or kilometer period to ensure long-term reliability.
We assure you that all of us at Mazda have an ongoing interest in your motoring pleasure and in your full satisfaction with your Mazda product. Therefore, the front seat belt pretensioners and curtain air bags may not deploy. National Highway Traffic Safety Administration for grading tires by tread wear, traction, and temperature performance. Even if the light goes out have your brake system inspected as soon as possible by an Authorized Mazda Dealer. Fold the trunk board into the position shown in the figure. When towing, trailer tongue load or king pin weight is also part of cargo weight.
Consult an Authorized Mazda Dealer as soon as possible even if the brake light is no longer illuminated. Consult an Authorized Mazda Dealer as soon as possible. You may be unable at times to arrive at your destination due to out-of-date information Warnings on a map disc. The dynamic stability control may have a malfunction. Should this happen, consult an Authorized Mazda Dealer as soon as possible.
This is the quickest and best way to address the issue. Make sure the cooling fan is operating, then turn off the engine after the temperature has decreased. The grade of tires available as standard or optional equipment on Mazda vehicles may vary with respect to grade. To enable seat belt automatic locking mode, pull it all the way out and connect it as instructed on the child-restraint system. If you shut off the engine while the light is flashing you won't be able to restart it. Up to 3 transmitters can be used with the keyless entry system per vehicle. Open the clip and slide the blade assembly in the direction of the arrow.