The factory manual instructs like virtual mechanic about maintenance, installation, servicing and fixing of errors. Pull the bulb straight out of the socket and push in the new bulb. To install, reverse the removal procedure. Box 1580, Station B, Mississauga, Ontario L4Y 4G3. This will automatically return the vehicle to the previously set speed.
Remove the wheel and tire assembly. Check the sidewalls to make sure there are no gouges, cuts or bulges. Using the special tools, disconnect the ball joint from the lower arm. This will automatically return the vehicle to the previously set speed. The use of accessory seat covers may prevent the deployment of the side airbags and increase the risk of injury in an accident. If you do not take these precautions, your vehicle may move unexpectedly and injure someone.
Production sequence number Engine number The engine number the last eight numbers of the vehicle identification number is stamped on the engine block and transaxle. Lubricate the knuckle bearing bore with anti-seize lubricant meeting Ford specification. They lift the child up so that the lap belt rests low across the hips and the knees bend comfortably. When the seat is down, the back of your wagon has a flat surface for carrying cargo. Using a suitable spring compressor, slightly compress the spring to remove initial tension. If a replacement oil filter is used that does not meet Ford material and design specifications, start-up engine noises or knock may be experienced.
The top of the high intensity area should touch the horizontal reference line, if not, the beam will need to be adjusted. Ford may change the contents without notice and without incurring obligation. Refer to Safety restraints for children or Safety seats for children later in this chapter. Do not apply heat or flame to the front shock absorber during removal or disassembly. Do not press or draw the wheel hub and bearing into place. Opening the trunk Press once to unlock the trunk or liftgate wagon. Refer to Fuel filler cap in the Maintenance and Specifications chapter.
The Dispute Settlement Board may not be available in all states. Lower the vehicle far enough to access the strut and spring assembly-to-body nuts. Remove the hub cap or wheel cover, the wheel hub retainer, and the washer. To access this information, special equipment must be directly connected to the recording modules. This manual will surely pay off when you perform the first oil change, spark plug change, or air filter change! The belt will click as it retracts to indicate it is in the automatic locking mode. .
For information on in-vehicle engine repair, as well as removal and installation of external components, see Parts A and B of this Chapter and Section 7 of this Part. Move the control to the full upright position, past detent, to turn on the interior lamps. Locate and carefully remove the engine oil indicator dipstick. It is a torque prevailing design and cannot be reused. Use tape or a rubber band to hold the vinyl to the left side of the tube. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
The engine must warm up to its normal operating temperature. Damage to the flange can occur. If the problems persist below this temperature, see your dealer or a qualified service technician. Refer to your scheduled maintenance information for more information. Conversely, a neglected engine may require an overhaul very early in its life. Power steering fluid reservoir 8.
This manual contains complete services and repair instructions which provided by our expert mechanic team members. This unique guide, also known as the factory service manual is the one delivered by the manufacturer to the authorized dealer; and while many publishers may claim that their manual is capable of covering a single model for many years ahead, this however is not an honest statement. Remove the nut, bolt and lower arm. Torque values must be used as specified during reassembly to make sure of correct retention of these parts. The name and color of the button may vary by manufacturer. Locate and carefully remove the engine oil indicator dipstick. Do not use steel rivets.